IC-V80 Sport VHF FM Transceiver
Specifications
| General | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| Frequency range | Tx 144–148 MHz
Rx 136–174 MHz* |
||||||||||
| Type of emissions | F2D/F3E (FM) | ||||||||||
| No. of memory channels | 207 (incl. 6 scan edges and 1 call) | ||||||||||
| Frequency stability | ±2.5ppm (-20°C to +60°C) at 25° C | ||||||||||
| Operating temperature range | –20°C to +60°C; –4°F to +140°F | ||||||||||
| Power supply requirement | 7.2 V DC | ||||||||||
| Current drain (at 7.2V DC) |
|
||||||||||
| Antenna impedance | 50Ω (BNC) | ||||||||||
| Dimensions
(proj. not incl.) |
58 × 112 × 30 mm; 2.28 × 4.41 × 1.18 in | ||||||||||
| Weight (approx.) | 140g; 4.9oz (without battery pack) 360g; 12.7oz (with BP-264 and FA-B2E) |
||||||||||
| Transmitter | |
|---|---|
| Output power (at 7.2 V DC) | 5.5 W (High) 2.5 W (Mid) 0.5 W (Low) |
| Spurious emissions | Less than –60 dB |
| Max. frequency deviation | ±5.0 kHz/±2.5 kHz (wide/narrow) |
| External mic. connector | 3-conductor 2.5 (d) mm (1/10″) / 2.2 kΩ |
| Receiver | |
|---|---|
| Sensitivity | 0.14 µV (typ.; at 12dB SINAD) |
| Squelch sensitivity | 0.1 µV (typ.; at threshold) |
| Selectivity | 70dB/50dB typical (wide/narrow) |
| Intermodulation | 70dB/65dB typical (wide/narrow) |
| Spurious and image rejection | 75dB (typical) |
| Audio output power
(at 10% distortion) Internal SP External SP |
750mW typ. (16Ω load) |
| External speaker connector | 3-conductor 3.5 (d) mm (1/8″) / 8Ω |
Applicable U.S. Military Specifications
Icom makes rugged products that have been tested to and passed the following MIL-STD requirements and strict environmental standards.
| Standard | MIL 810 F | |
| Method | Proc. | |
| Low Pressure | 500.4 | I, II |
| High Temp. | 501.4 | I, II |
| Low Temp. | 502.4 | I, II |
| Temp. Shock | 503.4 | I |
| Solar Radiation | 505.4 | I |
| Rain Blowing/Drip | 506.4 | I, III |
| Humidity | 507.4 | – |
| Salt Fog | 509.4 | – |
| Dust Blowing | 510.4 | I |
| Vibration | 514.5 | I |
| Shock | 516.5 | I, IV |
Also meets equivalent MIL-STD-810-C, -D and -E
Ingress Protection Standard: Dust and water – IP54 (dust-protection and water resistant)
All stated specifications are subject to change without notice or obligation.